Topic outline

  • TP Electrical measurement

    Collapse all Expand all
    • forum icon
      Forum
      TP Electrical measurement Forum

      Master 1: Energy Physics and Renewable Energy


      Unité d’Enseignement

      VHS

      V.H hebdomadaire

      Coeff

      Crédits

      Mode d'évaluation

      14-16 sem

      C

      TD

      TP

      Autres

      Continu

      Examen

      UEM1

       

       

       

       

       

       

       

       

       

          Mesure électrique

      30h

       

       

      2h

       

      3

      3

      33,33%

      66,67%

      Multimetre Numérique LCD avec antichoc DT-838 – DZBRICO


    • page icon
      Page
      Contact form Page


      Faculty: Science 
      Department : Physics
      Target public: Master 1
      Speciality : Energy Physics and Renewable Energies 
      Subject title: TP Mesure Electrique
      Duration: VSH 30h (TP 2h)
      Credits: 3
      Coefficient: 3
      Teacher in charge of the subject : Djedid TALOUB
      Contact: djedid.taaloub@univ-msila.dz
      Availability: At the department : Sunday and Wednesday or by appointment.
      By email: I undertake to reply by e-mail within 24 hours of receiving the message, except in the case of unforeseen circumstances.

  • Practical Work N°: 01 Photovoltaic Panels


    The aim of the PV Table is to study the factors that affect the performance and efficiency of photovoltaic cells. We therefore carried out 5 experiments in which we were able to:  

    - Identify the main characteristics and parameters of photovoltaic cells.

    - Determine the influence of illumination on the performance of photovoltaic panels.

    - The influence of angles of incidence and azimuth on the performance of photovoltaic cells.

    - study the influence of connections on open-circuit voltage and short-circuit current.


  • Practical Work N°: 02 Installation of Photovoltaic Panels in Series

    1-What is series connection of panels?

    Series connection means that you connect the solar panels one after the other, so that the electrical current flows from one panel to the next. The current is therefore the same in all the panels. The total voltage of the system is the sum of the voltages of each panel. For example, if you connect three 12-volt panels in series, you will get a total voltage of 36 volts.

    To connect in series, connect the positive poles of one module to the negative poles of another.



  • Practical work N°: 03 Parallel installation of photovoltaic panels


    Basic principle

    Series or parallel connection is an important concept in electricity for connecting electrical components in a circuit. Understanding these two types of connection is essential to understanding how electrical circuits work.

    In a parallel connection, on the other hand, the components are connected side by side, so that each component has its own path for the current to flow. In this type of connection, the electrical voltage is the same for all the components, but the amount of current flowing through each component is different. If one component fails, the other components can continue to operate normally.


  • Bibliographical references

    - - Electrical circuits and measurements, Dunpin Hong, Dunod, 2009

    - - MESURES ELECTRIQUES APPLIES, M Abati , A. Roux, Delagrave 1989.

    - - Electrical measurements, Jean Niard , Nathan  1981

    - - Electrical measurements, Baurand J, Masson (1961)